Universal Remote Control MX-800 Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
z Page 7 July 28, 2005
19. After programming all the buttons, write the macros from the IR Configuration Tool to the
i-PoRT-IRs. Menu: IR > Write. IMPORTANT: Do not push any keys on the MX-
700/800 until the IR Write is finished. The window below comes up. Watch the black
screen near the bottom of the IR Configuration Tool window. Once it stops scrolling, the
Write is finished. This takes a minute or so.
20. Test the MX-700/800. Reprogram buttons as necessary making sure to write the
changes to the i-PoRT-IRs after any changes are made (Menu bar: IR > Write).
Example #1: Controlling a Dimmer Switch
In this example, the following i-LiNE network setup will be used. The dimmer switch (device #7)
will be controlled with the MX-700/800 remote control. This example assumes that the MX Editor
Software has already been installed on the computer.
1. Computer 5. Null Modem Cable
2. Serial Cable 6. i-PoRT-COM
3. i-PoWER-M1p 7. i-ON-D Dimmer Switch
4. i-PoRT-IRs 8. i-ON-MB Multibutton Switch
L
L
L
e
e
e
t
t
t
s
s
s
G
G
G
e
e
e
t
t
t
S
S
S
t
t
t
a
a
a
r
r
r
t
t
t
e
e
e
d
d
d
!
!
!
1. Connect the MX-700/800 to the serial port of the PC with the supplied cable.
2. Bring up the MX-700/800 editor on the PC.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Commentaires sur ces manuels

Pas de commentaire