Universal Remote Control MX-800 Manuel d'utilisateur télécharger pdf (Page 6)

z Page 6 July 28, 2005

11. Put the MX-700/800 in program mode. Hold MAIN and ENT for about 10 seconds until

SETUP comes up. Then select LEARN.

12. Go to the first button on the MX-700/800 that you wish to program. Remote says

READY.

13. Hold the MX-700/800 as close as possible to the left side of the red window on the i-

PoRT-IRs. Programming will fail if the MX-700/800 is too far away.

14. Transmit the IR code for the first button to the MX-700/800 (Menu bar: IR > Transmit IR

code). The red LED on the i-PoRT-IRs will start flashing.

15. The MX-700/800 says GOOD at the top of its screen and Saved at the bottom of its

screen. The red LED will stop flashing and go off.

16. NOTE: If the remote does not say GOOD and Saved when you Transmit IR code, it did

not program the button. Hold the remote closer to the left side of the red window of the i-

PoRT-IRs and try transmitting again.

17. NOTE: MX-700/800 will go out of SETUP mode after a time. If it does, just hold MAIN

and ENT again to put it back into SETUP mode.

18. Repeat steps 12-17 to program the remaining buttons on the MX-700/800.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Universal Remote Control MX-800 Manuel d'utilisateur Page 6