After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
After Sales Support
Telephone: 1300 663 907
Internet: www.winplus.com.au
17 10
Entering Device Codes Directly
Switch on the device for which you want to program the
remote control. If your device is a VCR or a CD or DVD player,
please insert a tape or CD/DVD.
To cancel the following programming at any time,
press EXIT (23) to return without saving any changes.
Press the EXIT button (23) multiple times until the
remote control has returned to standard mode.
1. Search for the first available code by using the device
type and manufacturer (see the code book).
2. Point the remote control to the TV set while entering
the commands.
3. Press the source device selection button of the device
you want to program. In this example, it is the TV button
(2). The display shows [TV].
4. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the
SET button (21).
5. Press the OK button (22). The display shows
[BRAND SRCH].
6. Press V (8) twice. The display shows [CODE SET].
7. Press the OK button (22). The message [TV] will blink
on the display. The current device code is the 4-digit
code below it.
8. Press the OK button (22) again. The first digit of the
current device code starts blinking.
9. Enter the four digits of the device code that you have
found on the list. To do this, press the numeric keys (3).
After you have entered the information, the first digit
will blink again. If you mistyped the code, you have
the chance to enter it again at this time.
Only for the device type AUX, a fifth digit must be
entered to set the device code. To do this, use the
following list.
0–TV
1–VCR
2–DVD
3–STB
4–DVR
5–AUDIO
6–Cable
7–CD
Executing a Macro
1. Press the MACRO button (28). No message will be
displayed.
2. Within the next 15 seconds, press any of the numeric
buttons (3) 1 to 6. The numeric button 1 corresponds
to Macro 1, the numeric button 2 corresponds to
Macro 2, etc.
3. The macro will be executed immediately. Make sure that
the remote control is within reach of all devices that you
want to control.
If you have enabled the backlight, it will blink during
macro execution. If there is no macro assigned to
the selected numeric button, the backlight blinks
briefly four times.
Erasing a Macro
1. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the SET
button (21).
2. Press (8) three times. The display shows [MACRO].
3. Press the OK button (22). The display shows [MACRO1].
4. Press or (8) to select the macro you want to delete.
5. Press the OK button (22). The display shows [SET UP].
6. Press (8). The display shows [DELETE].
7. Press the OK button (22). The display shows
[SURE DELET].
8. Press the OK button (22) to confirm the deletion.
9. The message [DELETED] will appear for a few seconds
and the device returns to the previous level.
10. Quit the process by pressing the EXIT button (23)
two times.
(48 pages)
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels