Universal Remote Control Thermo Control Manuel d'instructions télécharger pdf (Page 49)

QUICK PROGRAMMING GUIDE FOR LT RTS CMO MOTOR

Resetting Motor Memory and Recording New Transmitter

Step 1: Perform a dual power cut in the following sequence:

1. Power-off 2 second minimum

2. Power-on 10 seconds

3. Power-off 2 second minimum

4. Power-on

The end product moves for 5 seconds in one direction, to indicate that the double

power cut has been recorded. The motor is in PROGRAMMING MODE for 2 minutes.

Step 2: Press and hold more than 5 seconds on the PROGRAMMING BUTTON

of the PREVIOUSLY recorded RTS transmitter/channel. The end-product jogs briefly

UP or DOWN indicating that the LT RTS CMO motor memory has recorded this

new transmitter.

>5 sec.

Resetting Back to FACTORY MODE

New Transmitter

>5 sec.

Previously Recorded Transmitter

Back to FACTORY MODE (To completely reset the LT RTS CMO motor’s memory)

Step 1: Perform a dual power cut in the following sequence:

1. Power-off 2 second minimum

2. Power-on 5 to 15 seconds

3. Power-off 2 second minimum

4. Power-on

The end product moves for 5 seconds in one direction, to indicate that the dual

power cut has been recorded. The motor is in PROGRAMMING MODE for 2 minutes.

Step 2: Press and hold more than 5 seconds on the PROGRAMMING BUTTON of

the PREVIOUSLY recorded RTS transmitter/channel. The end-product jogs briefly

UP or DOWN indicating that the LT RTS CMO motor memory has been completely

cleared.

The motor cannot be reset if it is already in FACTORY MODE.

Adding Additional Transmitters/Sensors

STEP 1: Using a paperclip or pen, press and hold the PROGRAM BUTTON

on the previously recorded transmitter until the awning jogs.

STEP 2: Using a paperclip or pen, press and hold the PROGRAM BUTTON

on the Additional (new) transmitter/sensor until the awning jogs.

(Single Channel)

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 92 93

Pas de commentaire

Universal Remote Control Thermo Control Manuel d'instructions Page 49