Universal Remote Control Thermo Control Manuel d'instructions télécharger pdf (Page 47)

Completing Programming of Transmitters

STEP 1: Identify the UP limit switch push button on the CMO motor head.

Press the button of the transmitter and let the end-product reach the required

UP position, then stop it.

STEP 2: Unlock the UP limit switch push button by pressing and releasing it.

STEP 3: Repeat the above operation to set the DOWN end limit.

STEP 4: Replace the protective cap.

Mechanical Limit Setting Mode

STEP 5: Press PROGRAMMING BUTTON on back of RTS transmitter to record

it to the motor memory.

Check the Direction of Operation

STEP 1: The DOWN button must correspond to DOWN on the end-product.

In case of an awning, it will open or extend the awning. If the direction is

wrong, change the direction.

STEP 2: Press and hold the (STOP) button.

STEP 3: Release the (STOP) button when the end-product jogs briefly

indicating that the change has been memorized in the motor. Verify that the

change took place before proceeding.

QUICK PROGRAMMING GUIDE FOR LT RTS CMO MOTOR

Initiate PROGRAMMING MODE

STEP 1: Assign the transmitter to communicate with the motor’s receiver, press

and hold the UP and DOWN buttons on the transmitter simultaneously.

STEP 2: Release both buttons after the end-product jogs briefly UP and DOWN

indicating that this transmitter can operate the motor during programming.

The LT RTS CMO motor will now operate in a momentary fashion.

PROGRAMMING MODE

In case of problems with setting of limits during PROGRAMMING MODE,

turn the power off to the motor for 2 seconds and then back on to

reset the motor. Please return to PROGRAMMING MODE to initiate

programming process.

White Button

Yellow Button

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 92 93

Pas de commentaire

Universal Remote Control Thermo Control Manuel d'instructions Page 47