Universal Remote Control CONTROL WR7 Manuel d'utilisateur télécharger pdf (Page 30)

Page 30

Erasing Commands - Overview

You can erase a single learned command, all learned

commands in each component mode, SimpleSound programming,

MacroPower commands, or re--set the remote to original factory

default settings.

Erasing a Single Learned Command from

One Component

STEP 1: Press the component button where the learned com-

mand is stored and the [ENTER] button at the same time for two

seconds until the component LED light turns on.

IMPORTANT: You have 30 seconds to perform the next

step while you are in programming mode. If you do not press a

button within 30 seconds, the component LED light will turn off.

The remote will exit the programming mode and you will have

to start over.

STEP 2: Press and hold the button you want to erase for two

seconds. The component LED light will blink twice to confirm

the erasure.

STEP 3: Repeat Step 2 to erase any other buttons in the selected

component mode.

STEP 4: To exit Erase mode, press and hold both the component

button and the [ENTER] button at the same time until the compo-

nent LED light blinks three times.

COMPONENT

BUTTONS

ENTER

WR7 1/13/08 12:18 PM Page 30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 48 49

Pas de commentaire

Universal Remote Control CONTROL WR7 Manuel d'utilisateur Page 30