Universal Remote Control CONTROL WR7 Manuel d'utilisateur télécharger pdf (Page 28)

Page 28

Transport Control ‘Punch Through’

This ‘punch through’ enables you to program the WR7 so that

VCR or DVD Transport Controls (PLAY, STOP, FF, REW, PAUSE,

SKIP and RECORD) will also operate in other component modes

on the remote control.

STEP 1: Press and hold the component button you want to

add Transport Control to, such as [CABLE/SAT] or [TV], and the

SELECT [SEL] button at the same time for two seconds until the

Component LED light turns on.

IMPORTANT: You have 30 seconds to perform the next

step while you are in programming mode. If you do not press a

button within 30 seconds, the component LED light will turn off.

The remote will exit the programming mode and you will have

to start over.

STEP 2: Press the [PLAY] button. The component LED light will

blink once.

STEP 3: Press either the [DVD] or [VCR] button that you want

to use as the source of Transport Control. The component LED

will blink three times to confirm it is saved.

SELECT

COMPONENT

BUTTONS

PLAY

WR7 1/13/08 12:18 PM Page 28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 48 49

Pas de commentaire

Universal Remote Control CONTROL WR7 Manuel d'utilisateur Page 28