Universal Remote Control CONTROL WR7 Manuel d'utilisateur télécharger pdf (Page 14)

Page 14

Auto-Search Method

The Auto-Search Method is a way you can scan through

all of the codes in the table to find the right code for

your component.

STEP 1: Manually or using your old remote, turn on the

component you want to program—for example, to program

your TV, turn on your TV set.

STEP 2: On the WR7, press the Component button

that you want to program (in this case the button that says

TV) and the SELECT [SEL] button at the same time. Hold

down both buttons for two seconds until the TV Component

button light turns on. This signals that you are in

programming mode.

IMPORTANT: You have 30 seconds to perform the next

step while you are in programming mode. If you do not

press a button within 30 seconds, the component LED light

will turn off. The remote will exit the programming mode

and you will have to start over.

ARROW

DOWN

ARROW

WR7 1/13/08 12:18 PM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 48 49

Pas de commentaire

Universal Remote Control CONTROL WR7 Manuel d'utilisateur Page 14