Universal Remote Control MRF-260 Manuel d'installation télécharger pdf (Page 6)

Page 3

Installation

1. Unplug the MRF-260i. Test all IR commands and macros line of

sight.

2. Power on all AV components including the TV. Turn on all of the

lights and lower all dimmers to 50%. Power on anything that may

create RF Interference (particularly devices with high speed

microprocessors or hard drives).

3. Check that the address wheel on the rear of the MRF-260i is set

to ID#0 (the interference “sniffing” position).

4. Connect the MRF-260i to its DC wall adapter and plug the wall

adapter into a live AC outlet. Place the MRF-260i in a location at

least 3 feet away from satellite receivers, cable boxes, HDTV

tuners, DVRs, PCs or any other device with a high speed micro-

processor (these generate broad band Radio Frequency

Interference -RFI). Of course, you should keep in mind that the

emitter cables are 10’ long.

MRF-260i BASE STATION

Check that the arrow pointer in the center of the wheel is pointed to 0, the

default “interference sniffing” position. If it is not, use a small flat blade

screwdriver (included) to set the RF ID# to 0.

The red POWER LED indi-

cates that the MRF-260i is

powered on.

The red STATUS LED flashes

differently, based on the

Address setting:

IF SET TO ID#0

The Status LED flashes

when it receives ANY RF

signal, including RFI. This

makes ID#0 ideal for

“sniffing” out RFI.

IF SET TO ANY OTHER ID#

The Status LED flashes ONLY

when it receives a correctly

addressed RF command.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Universal Remote Control MRF-260 Manuel d'installation Page 6