Universal Remote Control MRF-260 Manuel d'installation Page 1

MRF-260i Installation ManualOptimizing Narrow Band Receptionwith Complete Control Remotes

MRF-260i BASE STATIONPage 7Controlling Four Identical Components/Zones There are several considerations to take into account when you areinstalling an

MRF-260i BASE STATIONPage 8default programming sets all of the devices to send both IR and RFcommands. If you look at the column for Flashers, you ca

Page 9MRF-260i BASE STATIONNote: Remember, the MRF-260i will only respond to selections 1through 4. Step 5 - Make sure that the ID# is set on both the

MRF-260i BASE STATIONPage 10Programming For Multiple Equipment LocationsYou can operate up to 15 different equipment locations, each withan MRF-260i a

MRF-260i BASE STATIONPage 11Limited Warranty Statement1. Limited Warranty and Disclaimers Universal Remote Control, Inc. (“URC”) warrants that the URC

MRF-260i BASE STATIONPage 12PROVISIONS HEREIN, WARRANTY DOES NOT COVER: (I) DAMAGEFROM MISUSE, NEGLECT OR ACTS OR NATURE, (II) MODIFICATIONS,(III) INT

MRF-260i BASE STATIONPage 13Such equipment is not eligible for URC tech support or software support,either.2. URC’S Limitations of Liability IN NO EVE

MRF-260i BASE STATIONPage 14Frequently Asked QuestionsCan I use flasher/emitters that I have already installed in the sys-tem to connect to the MRF-26

NOTEPage 15

MRF-260i Installation Manual ©2007-2013 Universal RemoteControl, Inc.The information in this owner’s manual is copyright protected. No part ofthis man

500 Mamaroneck Avenue, Harrison, NY 10528 Phone: (914) 835-4484 Fax: (914) 835-4532 www.universalremote.comThis equipment has been tested and found to

TABLE OF CONTENTSIntroduction 1Features and Benefits 2Parts Guide 2Installation 3Testing 5Front Blaster Overload 6Disabling the Front Blaster - Step b

Page 1MRF-260i BASE STATIONIntroductionThe MRF-260i base station is an “addressable” base station. RFAddressing gives you the ability to control as m

Page 2MRF-260i BASE STATIONFeatures and BenefitsInterference Rejection and Extended Range via Narrow BandThe MRF-260i receives RF (radio frequency) si

Page 3Installation1. Unplug the MRF-260i. Test all IR commands and macros line ofsight. 2. Power on all AV components including the TV. Turn on all o

Page 45. Observe the Status LED of the MRF-260i. If it is glowing or flick-ering you must relocate the MRF-260i to a location where theLED doesn’t fli

MRF-260i BASE STATIONPage 5TestingTest a few commands for each device before fixing the flasher inplace on the front panel of a device.Since TiVo, Rep

MRF-260i BASE STATIONPage 6Front Blaster OverloadA few models of audio/video components can be overloaded by theFront Blaster. If you are having inter