Universal Remote Control ONE FOR ALL PVR 6 Guide de l'utilisateur télécharger pdf (Page 13)

2. Enter 9 - 9 - 5. The LED will blink twice.

Then press

POWER once.

3. For the first device you want in the power

on sequence, press its device key (e.g.,

CBL/SAT) once.

4. Repeat step 3 up to five more times to add

desired devices to the power-on sequence.

5. To save the settings and exit the program,

press and hold

SET until the LED blinks

twice, then release

SET.

Operating Master Power

1. After programming, point the remote

control at the devices and press

POWER

for at least 2 seconds to sequentially turn

on or off your devices.

NOTE: When POWER is pressed for less than

2 seconds, a power command will only be sent

to the currently-selected device. This allows you

to still individually power devices on or off.

2. You will see the devices turn on or off

according to your programmed sequence.

NOTE: The currently-selected device will always

turn on first, followed by the remaining

programmed sequence.After the master power

sequence has been completed, the remote control

will be set to control the first powered-on device.

NOTE: If one or more devices does not have a

POWER key, the power off/on sequence may be

slightly delayed when the remote control signals

the device(s). This action is normal.

Clearing Master Power

1. Press and hold SET until the LED (red light)

blinks twice, then release

SET.

2. Enter 9 - 9 - 5. The LED will blink twice.

Then press

POWER once.

3. Press and hold

SET until the LED blinks

twice, then release

SET. Master Power is

now cleared.

OFA 6 PVR 2/15/03 9:25 AM Page 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Universal Remote Control ONE FOR ALL PVR 6 Guide de l'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Télécommandes Universal Remote Control ONE FOR ALL PVR 6