Universal Remote Control MRX-10 Manuel d'installation télécharger pdf (Page 6)

Front and Rear Panel Descriptions

Front

The front panel consists of 4 indicator lights which will illuminate

when in use.

Power: Illuminates when the power supply is connected to an outlet

Status: Flashes in blue when an RF or Network signal is received.

Sensor: Illuminates to indicate that it is sensing the presence of

composite video or AC or DC voltage.

Ethernet: Illuminates when connected to a Network Router

Reset: Press the reset button located under the MRX-1 to restart the

unit.

Rear

The rear panel ports are:

Power: Provides connection to included 12V/1Amp Power Supply.

Ethernet: Provides connection to LAN(Local Area network) via RJ45

cable.

Relay NO, NC, COM: Provides configurable switch closure control.

RS-232 Ports: Two RS232 ports provides direct control.

Sensor: Provides connection to one URC Voltage Sensor (VS-1006)

or to one URC Video Sensor (VID-6) for status in sensor based

macros.

IR IN: Allows MRX-1 control from a base station such as a MRF-260

(IR Routing capability is lost from commands coming from the MRF-

260)

MRX-1 BASE STATION

Page 3

Power

Status

Sensor

Ethernet

Power

Relay:NO,

NC, COM

RS-232 Ports

Sensor

IR IN

IR Outputs: #1-6

RFTX Port: #6

RF IN

RF Out

RF ID

Reset: Bottom

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Pas de commentaire

Universal Remote Control MRX-10 Manuel d'installation Page 6